Microsoft Windows Server 2003 Inside Out Inside Out (Web hosting support)
Microsoft Windows Server 2003 Inside Out Inside Out Chapter 6 RIS generates massive traffic loads One thing to keep in mind is that client installations generate large amounts of network traffic because between 700 MB (Windows XP) and 1.5 GB (Windows Server 2003) of data is passed over the network with each installation; DHCP typically has far less traffic. In most organizations, a RIS server is an enterprise-class server that is also used for software installations. In contrast, the typical DHCP server might, in fact, be a desktop-class system running Windows Server 2003. Obviously, if the latter case is true in your environment, you shouldn t combine RIS and DHCP on the same server no matter the size of your network. Building a RIS Server: What s Involved Now that you know how RIS works, its limitations, and design considerations, you are ready to deploy RIS. The procedures you must perform to get RIS up and working are as follows: 1 Install the RIS server and make it a member of the Active Directory domain in which the RIS clients are located. Be sure the server either has multiple hard disk drives or that you partition the drive so that the boot and system partitions can be separate from the RIS installation drive as it must be. 2 Add RIS to the server and then reboot it. Afterward, run the Remote Installation Services Setup Wizard (RISetup) to prepare the server to receive RIS images and put an initial image on the RIS partition or drive. When you do this, the RIS server is ready for use and you can add additional images to it by using RIPrep. The finer details of step 2 are covered in the next section of this chapter. Installing RIS The RIS services, like most network services, are not installed by default when you set up Windows Server 2003. Before installing RIS, you should verify that the computer on which you are installing RIS meets the baseline system requirements for RIS operations for both hardware and software, as well as partition configuration and available free space. RIS Server Requirements At minimum, the RIS server must meet the following requirements: . The computer must be running Windows Server 2003, Standard, Enterprise, or Datacenter Edition. . The server cannot be multihomed; it must have a single supported 10- or 100-MB network interface card (NIC) with TCP/IP installed. 158 Part 2: Windows Server 2003 Installation
Note: In case you are looking for affordable webhost to host and run your web application check Vision http web server services