Using Remote Installation Services (Web hosting domains) Initial RIS Configuration To
Using Remote Installation Services Initial RIS Configuration To configure the Remote Installation service, follow these steps: 1 Start the RIS Installation Services Setup Wizard on the RIS server by clicking Remote Installation Services Setup on the Administrative Tools menu or by typing risetup at a command prompt. 2 Specify the folder to use for RIS. Here, you select the disk location to contain RIS installation images and related files, as shown in the following screen. The folder must be on a local fixed drive that is formatted with NTFS version 5 or later (meaning an NTFS folder formatted previously under Windows 2000 or later) and that is not the same drive as the server s operating system. Tip Allocate adequate free space for RIS images The RIS image folder should have substantial free disk space (4 GB minimum), because installation images average over 700 MB, and most RIS installations will house multiple installations of more than one operating system as well as image variants for the same operating systems. Depending on the range of operating system (OS) images to be supported in your environment, and the frequency of adding new OS images, you might want to put RIS on its own partition with many gigabytes of free disk space. In our installation, a separate 60-GB drive is used as the RIS image folder. 3 Set initial RIS functionality. You can define whether RIS responds to clients at all and control the initial status of the RIS service after this setup wizard is completed (as shown in the screen on the following page). When the server is configured to respond to clients, security can be tightened by instructing RIS not to respond to unknown clients. Chapter 6 Part 2: Windows Server 2003 Installation
Note: If you are looking for high quality webhost to host and run your jsp application check Vision florida web design services